Help-Desk

The error message "Blank not correctly clamped" is an error message during the moulded part measurement. The machine detects a deviation in the po...

The error message "Check blank diameter" is an error message during the measurement of the moulded part. The machine detects a deviation between t...

The Blue44 holder is not inserted in the same way on all machine types. The positions on which milling takes place are defined in the CAM and can be seen t...

When inserting the blank into the holder, first make sure that the support of the holder is clean. Then insert the blank and push it up to the contact s...

When inserting the holder, first remove the clamping ring and the four cylinder head screws for round machining. Before screwing in the holder, clean th...

If the geometry or the milling result is not round, check whether the blank dimensions specified in the software correspond to the actual dimensions of the ...

Before a preface is milled, it must be measured. To do this, the holder and the blank must be inserted into the machine and the corresponding jobs must b...