A brief overview of all categories available for selection in the strategies.
Restmaterial Machining
Cat 1. Undercut machining
Cat 2. Restmachining Preci Vertix
Cat 3. TK-Soft Restmachining
Cat 4. Retention holes
Cat 5. Full anatomic re-finishing
Secondary Telescope Machining
Various fitting parameters can be individually set for each telescope. The amount to be re-machined is determined by categorizing the boundary lines.
Cat.1 = Free entry of a value in the overwriteable parameters
Cat.2 = 2µm
Cat.3 = 4µm
Cat.4 = 6µm
up to a maximum of Cat. 16 = 30µm
See attached PDF. (this PDF provides explanations of the categories)